|
|
|
|
#1
02-05-16, 10:53
|
|||
|
|||
i've got plenty of soft white felt if you need it
__________________
_______________________ 1941 mk1 mortar Carrier 1941 Mk1* Carrier 1942 Mk1* Carrier 1943 T16 Carrier 1945 Mk3 Dingo 1941 Mk3 Covenanter 1941 Mk4 Churchill AVRE (now sold) 1944 Mk6 Cromwell (now sold) 1952 Mk3 Centurion 1952 ARV Centurion 1952 ARV Centurion 1953 Mk3 Centurion (breaking) 
|
|
#2
02-05-16, 10:59
|
||||
|
||||
|
Cheers Rick.
Just need the measurements now  Had not realised it was made from so many bits !
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#3
02-05-16, 11:01
|
|||
|
|||
|
can't help you there, i need one myself
__________________
_______________________ 1941 mk1 mortar Carrier 1941 Mk1* Carrier 1942 Mk1* Carrier 1943 T16 Carrier 1945 Mk3 Dingo 1941 Mk3 Covenanter 1941 Mk4 Churchill AVRE (now sold) 1944 Mk6 Cromwell (now sold) 1952 Mk3 Centurion 1952 ARV Centurion 1952 ARV Centurion 1953 Mk3 Centurion (breaking)
|
|
#4
02-05-16, 11:02
|
||||
|
||||
|
Looking at the image it appears as though the whole assembly hangs from the top engine cover !
Blimey
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#5
02-05-16, 11:23
|
|||
|
|||
|
Rich,There is a bolt in each lower corner that go into the lower engine cover rails. (see where the slots are for the rails)
The bottom of the fan circle piece sits on the shoulder of the bit under the engine bed rail forward bits. The radiator top mount (tongue) goes through the slot at the top. I can give you measurements, but not until next week. I am busy till then.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 02-05-16 at 11:29.
|
|
#6
02-05-16, 11:47
|
|||
|
|||
|
The four bolts that go down from the top go into captive nuts (bits of steel welded on) One half over laps the other at the centre. the felt is held on with bif. rivets. The felt goes over the top pipes and under the top mount slot.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
|
#7
02-05-16, 17:03
|
||||
|
||||
|
Cheers, it looks like British over engineering as always
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#8
02-05-16, 18:12
|
||||
|
||||
|
I remember restoring my carrier years ago and when it was all finished I then came across those shroud pieces and looked at the work involved to try and fit them in there. I decided to leave them out as I wasn't up to the challenge of trying to disasemble everything again to get it installed. Then for it's first parade the radiator decided to blow up on me! (Radiator was plugged causing poor circulation!).Must have been a sign as I had to tow the carrier home and take everything apart again to change the radiator.Made sure the shrouds went in that time!
Regards,Derk
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early)
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: radiator shroud to suit lp2 carrier | Dale Jordan | For Sale Or Wanted | 1 | 18-04-16 04:46 |
| CAB Radiator Shroud F15 | James Y | The Softskin Forum | 1 | 25-12-15 01:07 |
| 1944 wasp flamethrower bren carrier canvas shroud cover | kevin powles | The Carrier Forum | 1 | 28-07-13 17:55 |
| Radiator shroud and front section take outs. | Svenn Ryen | The Restoration Forum | 3 | 28-03-13 12:46 |
| Mk1 radiator shroud | Philliphastings | The Carrier Forum | 1 | 20-01-11 10:59 |
Hybrid Mode
