An Introduction: Chris Collins and Morris Tilly Project

[maple_leaf_eh]

I've seen roadkill animals with more meat on them than this unfortunate specimen.

Good luck

[Itzik Merkado]

Our warehouse waiting for better days

[jack neville]

Having finally got all the Tilly photos on to a computer that is easier to load on this forum than using an Ipad it is time for an update and a few more 'before' photos.

Chris aquired over a peeriod of about four months either complete(?!) or the remains of a total of four Morris Tillys out of what we beleive was forty that came to Australia. All so far have been 'knockdown' versions with removable rooves. There was enough to complete two vehicles as detailed above. To date we have completed the rebuild of two rear axles, front axles, two sets of springs, tailshafts and steering boxes. Out of the total of about ten complete sets of front and rear springs I salvaged enough leaves to reset two complete sets. Many of the leaves were broken or had splits running lengthwise, which I had never seen before. Many hours of hammering to reset the leaves sand blasting and reassembly.

[jack neville]

This original vehicle had come via Hugh Davis from outback South Australia. I believe when Hugh rescued it it was upside down which may have saved alot of the sheet metal and at some stage an excavator bucket had been rested on its roof. It looks alot worse than it is with all the timber having rotted away. The initial thought was it could be rebuilt but after assessing the complete Tilly from Len Watkins the chassis of both are a bit too far gone.

[jack neville]

More photos

[jack neville]

more photos

[jack neville]

We were short of an engine with this original Tilly hence the lead to Len Watkins and the purchase of the complete Tilly plus the remains of a second which had a complete engine still in situ. We got the complete vehicle running, and the engine was stripped from the othe remains.