|
|
|
|
#1
09-04-16, 04:02
|
||||
|
||||
flame
I believe that a oxy cutting flame will not effect cast iron. Would it be possible to blow out the broken stud with a oxy/acc torch ?
Another method https://www.youtube.com/watch?v=bSOg7aQ44eg
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad 
|
|
#2
09-04-16, 06:26
|
|||
|
|||
|
Jacques, I put a head on(because the Ford studs are a close fit in the holes in the V8 head), made a sleeve for the stud hole, and bored a a pilot hole through the sleeve on the lathe. This was my method to get a hole through the centre of my broken studs. It worked well.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what size is the head stud threads etc for 24 stud v8 merc | RichardT10829 | The Carrier Forum | 11 | 06-12-11 21:14 |
| Morris Commercial CS8 / C4 | Richard Farrant | The Softskin Forum | 0 | 04-12-05 14:06 |
| Morris Commercial C4 | Rolf S. Ask | The Softskin Forum | 16 | 17-11-04 01:06 |
| Frozen Stud Removal – Aircraft Dye Penetrant | Bob Moseley (RIP) | The Restoration Forum | 4 | 28-03-03 07:11 |
| Engine stud removal | Mike K | The Restoration Forum | 3 | 01-03-03 23:36 |
Hybrid Mode
