Lower Rad Hose

[Michael R.]

Alright, I believe I got it. If the double pulley pumps all have the same length intake (the male portion pointing towards the bottom of the radiator) they will be the same as shown in your posted image. As such, the 8BA-8286-B series lower radiator hose will fit the factory standard dimension for mounting in the Canadian series of 85hp universal carriers.

The thought of variance creeps back into the scheme of things if someone is running with water pumps that do not have the same length intake.

[rob love]

So while the hoses could be an inch or so longer, it looks like this will be a good fit. Success. Anther issue gone.

You would not believe how many photos of preformed hoses I went through on google before coming across these ones, which as it turns out, were not far off the regular Mac's page for this vintage of an engine.

[super dave]

Originally Posted by rob love

So while the hoses could be an inch or so longer, it looks like this will be a good fit. Success. Anther issue gone.

You would not believe how many photos of preformed hoses I went through on google before coming across these ones, which as it turns out, were not far off the regular Mac's page for this vintage of an engine.

Yes another replacement part solved

[rob love]

I am back to working on the 2VP carrier, and after Lynn had expressed some concern about the length of these hoses on another thread here: http://www.mapleleafup.net/forums/sh...highlight=hose I was having doubts if these hoses were the solution. Happy to report that they are going to work out just fine. They could be an inch or two longer, but as they are, there is just enough rubber onto the tubes to make the required connections.

In the photo you can also see the results of long term outdoor storage on the floor of the carrier. Hopefully after all this work the unit will store it inside now.

[Lynn Eades]

With ref. to Michael R's post #20, I would expect that the 8 1/2" hose was for use with the short inlet pumps.
The 8BA hoses work well shape wise and the length is enough if fitted with care. Now I wonder how a straight piece of silicon hose would go as an alternative? (not that I have a plan to try some)
Does it bend a bit, without kinking or is it the same as a bit of std. rubber hose?

[super dave]

Originally Posted by Michael R.

Alright, I believe I got it. If the double pulley pumps all have the same length intake (the male portion pointing towards the bottom of the radiator) they will be the same as shown in your posted image. As such, the 8BA-8286-B series lower radiator hose will fit the factory standard dimension for mounting in the Canadian series of 85hp universal carriers.

The thought of variance creeps back into the scheme of things if someone is running with water pumps that do not have the same length intake.

My pump outlet measures about 3 3/4" long from the machined portion of the pump where it bolts to the block to the tip where the hose attaches to it. If it is the single pulley water pump there might be enough length of hose to make it work.