Chevrolet CMP C15 cab 11 body 2A1

[Alex van de Wetering]

Jacek,

It's hard to see in the pictures, but it looks like it could be 1.109" diameter and about 6,75"long?

Maybe 1.109 X 6.812?? This is a size available from MOOG and ACdelco and marked as "Chevrolet truck 1941".

MOOG 8336B
ACDELCO 45F0023

But....this is only based on what I think I can see in your pictures.


Alex

[Jacek Nitkiewicz]

total lenght 6" 3/4 , diameter 1" 1/8,

[Jacek Nitkiewicz]

Just came back from reconditioning.

[Jacek Nitkiewicz]

Next small step. New lifter from Filling Station.

[Jacek Nitkiewicz]

I'm looking for tie rod end for my CMP.
Diameters of threads are 1 1/4 " and 2 1/4 " .
They don't have it on Chevy Parts and I couldn't find them on Dirk's page also.
Help appreciated.

[Bob Carriere]

I do not recognize these as CMP and you will no doubt have to search for civilian models from the 1937 or 1938 to 1940 for similar one ton or 1.5 ton listings.

Are you sure they need replacing ? Early tie rod ends for CMP could be taken apart to inspect for excessive wear........ can yours be disassembled?

Seems that the C15 front axle is almost a full civilian transplant right from the factory.

Good luck.

[Alex van de Wetering]

Jacek,

I bought the Tie rod ends for my C8 from Jim Carter (OldChevytrucks). Just like you I wasn't having much luck searching for a replacement using the part number. In the end I just asked for the diameters of the treads and the TPI and found a match. I bought ME348L and ME348R; suitable for the C8, but I think those for a C15 are heavier.

Edit: maybe ME537R and ME537L would work for the C15?
http://www.oldchevytrucks.com/cart/i...es=tie rod end


regards,
Alex