![]() |
#11
|
|||
|
|||
![]()
Hi Dale, put all your rods in including the accelerator rod. The clutch rod goes along side the starter motor by memory and definitely not around the exhaust. When fitting the engine just make sure a guy is easing the clutch and Acc. rods around the starter , and to the side ,as the engine is lowered. When the two rods are connected , make sure the bend is right so when you put your foot on the pedal it does not touch the starter motor terminal .Make sure the 2 bottom rubber hoses for your radiator can side on your water pumps easy, and push them hard back on the water pumps, length should be 110mm for ease of sliding onto rad. outlets. Top hoses should be about 85mm long. Leave gen. off so you do not stick the blades in the fan when lowering. You can leave the fan belts on though . Gap between your 2 flanges on the 8 point coupling should be 8mm approx. Make sure speedo cable is tucked out of the way. You can also leave the 2 exhaust pipes in the floor elbows, and with a guy either side when lowering, they can ease them up onto the 2 studs as the engine comes down to rest, so you are making sure they do not get jammed. Also do a trial fit with basic engine to make sure you are shimmed to height on the gearbox mount, and that the rubbers and bolts can slide easy in the steel flanges for ease of making this final connection. Do not force the 8 bolts to line up in the holes, they should just push in by hand if the 2 flanges are parallel and centred, that is why you should try with a pretty bare engine and even your rods removed for this exercise, before the final fitting and bolt up of engine .Cheers.
__________________
Valentine MkV Covenanter MkIV Lynx MKI and MKII Loyd Carrier / English / Candian / LP. M3 Stuart Last edited by Andrew Rowe; 01-10-15 at 08:09. |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |