|
|
#11
26-10-14, 01:37
|
|||
|
|||
Take a look at these two angles
Hi Jerry
The link below goes the top of the lower windshield ledge which reads as 1 1/2 degree up angle toward the front http://canadianmilitarypattern.com/R...02nd%20004.jpg Which compared with under side of the body which seems shows the same angle this would seem to indicate that top of the window ledge should be parallel to the floor. http://canadianmilitarypattern.com/H...lsofAngles.htm Wonder if someone else could confirm on another HUP also does anyone have a way of measuring these angles with a higher accuracy? Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Data Plate | Ian Johns | The Softskin Forum | 11 | 22-07-14 22:44 |
| Data plate info needed | Jordan Baker | The Softskin Forum | 8 | 07-12-12 18:56 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Ford 15A 2B1 Body: help needed | Fabio | The Softskin Forum | 7 | 14-10-08 21:40 |
| New Zealand Ford/Marmon-Herrington recovery body info needed | Hanno Spoelstra | The Softskin Forum | 6 | 23-07-06 13:07 |
Threaded Mode