LP2 VR 2225 Build

[ozm29c]

Originally Posted by Dale Jordan

Need help with wiring for my conduit, is it best to buy colored wire as per manual what about sizes is 4 mm PVC OK . I'm not sure to go 12 V or 6 V Any advice would be great need to get this job out of the way to move forward with build .. Dale

Dale,
This company may be able to offer some of the advice that you are seeking;
http://www.vinwire.com.au/index.htm
Cheers
John

[Lynn Eades]

Dale, it is important that you decide, or put the wiring in for 6 volt.
It needs to be a heavier cross sectional area for 6 volt than for 12 volt.

[Dale Jordan]

Test fitting conduit and terminal box near the engine rail , can someone tell me if this looks correct I've been working off photos only as there is know detail drawings in the manuals . Also the 1" tee what wires come out of it . I'm not sure









My Shepherd crook turned up today as well

[Mick Sutherland]

Looking good Dale.
Will done

[Dale Jordan]

Picked up a nice 1935 horn the other week they are getting hard to find , and it works . I'm on two weeks holidays should have the conduit finished and air scoop fitted . I'm having a wiring harness made up next week then the drivers compartment can be finished off .. I gave the outside upper hull it's final coat of paint to blend it all together yesterday . This Time I up graded to Protec's 342 spraying enamel 30% flat khaki green No 3 much , much , better then the equipment enamel very easy to spray . It looks flat in the flesh but has an egg shell feel to it . Dale

[Dale Jordan]

My LP2 Carrier mirror bracket from Darrin turned up today . This is a real nice peace of engineering well done Darrin . I could not be happier with it , if anyone else needs one , don't miss out . Ps I'll bend my arm as per the template as my carrier is later then Darrin's . Dale

[Dale Jordan]

I've moved along a bit more with conduit layout can some one tell me if this is correct ?? before I add the loom . Dale