Daimler Ferret Restoration - Canadian Service

[Neil Smith]

Yesterday I finished stripping the interior of the hull with the exception of the wiring harness. I'll get to that later. Looks like I'm going to need to replace a number of the studs on the floor as some are missing and some are damaged by corrosion.

What do you guys do to replace studs? I have read up on what a stud welder is, but don't have one and will need to see who does. Alternatively, can you drill through the armor and weld in a bolt? Any advice will be appreciated.

Here's some pictures of the typical canadian jerrycan holder that was fitted, I'll have a go at repairing it while I gather information on the stud replacement.