|
|
#33
08-09-14, 04:30
|
|||
|
|||
Excellent . Thanks Lynn and Euan . So the best thing to do for me is to drill two new holes in the rear tube part just need to know the correct orientation between the gear stick up front and the gear speed control aft are they in line with each other ? or when controller is hard up against the engine rail aft is the gear shifter up front facing towards the drivers seat as if in 1st or second gear . A photo would be great if some one has their linkage out on the shed floor .. or do I just rotate it 90 % from the old holes and hope the ones in the tube are correct which they should be ? Dale
__________________
1944 GPW and Bantam trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Threaded Mode