|
|
#5
22-06-14, 05:33
|
|||
|
|||
479-3
Dimensions and pics
1/4" thick 1 1/2" wide 15 1/2" long (but I would check this against your hull to ensure that it is long enough to engage with the locating tabs welded to the centre bulkhead) the ground radius/curve is roughly 3/4" in on both sides of the upper corner. pic will show where the hold are, but this is not that important as it is not seen. Holes must be countersunk for screw heads chamfer is about 1/2" in, this assists with locating into those tabs welded to centre bulkhead
__________________
1943 Ford GPW Jeep "Follow Me" 1943 MBT trailer 1943 Dodge WC-57 Command Car 1943 Chev C60L Army Cargo Truck 1941 LP2 VR 731 Bren Gun Carrier 3" Mortar Carrying Under restoration: 1940 LP1 Bren Gun Carrier 194? 1 Ton Trl Ben Hur 1942 C15A with sunshine cabin MVPA 31338 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Not sure where the rest is... | Richard Coutts-Smith | The Carrier Forum | 6 | 21-10-12 03:36 |
| Mk 1 firing rest variations | BCA | The Carrier Forum | 2 | 24-07-12 14:55 |
| Tpr George Hemmings another Kangaroo at rest | Spurrat | The Sergeants' Mess | 3 | 26-04-08 06:46 |
| Thanks for ruining it for the rest of us!! | Darrell Zinck | The Sergeants' Mess | 3 | 16-10-07 18:58 |
| Machine Gunners foot rest ? | Graeme Stephens | The Carrier Forum | 7 | 17-08-05 04:07 |
Threaded Mode