|
|
|
|
#1
23-03-14, 20:31
|
|||
|
|||
Cleaver set up
Hi Again Grant
Very cleaver way of getting the slant in the bottom of the rifle but supports. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
#2
23-03-14, 20:58
|
|||
|
|||
|
Front axle pivot pin removal and installation tools
Using the info from service bulletin "Item 195" (attached), which gives a revised process for adjusting the pivot bearings on all 4x4 and 6x6 CMP vehicles, tools were made to drive in the pivot pins for both large and samll axle ends and 3 sleves were made to use when pulling the pins out. The 3 extraction sleeves were made as I didn't have a long enough fully threaded bolt to hand so had to make the pull in stages limited by the length of the threaded part of the bolts.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2016 at the Hammond Barn | RHClarke | The Restoration Forum | 83 | 08-01-17 18:22 |
| 2015 at the Hammond Barn | RHClarke | The Restoration Forum | 113 | 31-12-15 21:00 |
| 2013 at the Hammond Barn | RHClarke | The Restoration Forum | 85 | 05-01-14 23:29 |
| 2009 at the Hammond Barn | RHClarke | The Restoration Forum | 322 | 02-01-10 16:05 |
| Hammond Barn Visit | Wpns 421 | The Softskin Forum | 1 | 15-12-09 03:17 |
Hybrid Mode
