Photos needed. Shed full of S**t Auction

[Tony Smith]

Originally Posted by Tony Wheeler

........ because the winch is fixed permanently in low ratio, so you'd need to shorten the handle to wind it rapidly, particularly when reeling in loose cable after winching.

Attachment 62966

I'd like to see a better pic of the mounting of the vertical post that supports the crank handle/shaft. Is it fixed in a vertical position? If it pivots about the chassis rail, then the drive gear could be withdrawn from the Low Ratio position and re-inserted in the High ratio position. The attachment of the cranking shaft to the drive gear seems too over-complex for a fixed alignment.