![]() |
#33
|
|||
|
|||
![]()
Im a hydraulics engineer and you dont want to get into thoes threads!!!
In hydraulics for example, 1/4" BSP thread to 1/4" hosetail (on a fitting) are completely different!! Think about it, 1/4" is roughly 6.5mm (tail size) but the threads are about 10mm (guessing as no guage with me in office!) ![]() ![]() ![]() JIC used to get me at first then it all fell into place! Some people use thread sizes but also can use DASH sizes 1/4" is -4 5/16" is -5 3/8" is -6 1/2" is -8 5/8" is -10 3/4" is -12 etc With JIC its a case of 7/16" is -7 1/2" is -8 9/16" is -9 5/8" is -10 3/4" is -12 7/8" is -14 1 1/16" is -17 1 3/16" is -19 etc ![]()
__________________
BETTER TO BURN OUT THAN FADE AWAY. |
|
|