|
|
#2
22-03-13, 11:09
|
||||
|
||||
TAC sign holders
Like these?
Sign plate new 1.jpg TAC Plate - Unit side.jpg Rear TAC plate frame.jpg TAC sign - Pass side, finished.jpg I had these made locally. The measurements were provided from the relevent Australian WWII Military beurocracy. They don't insert from the side, but top. Make sure you do your recesses REAL deep, so you don't foul the sliding of the plate. You probably already know that. The smaller plate you see in first photo is a more modern Australian one from a Land Rover, that I sent to the steel shop, so they knew how what I was wanting. appendix-a.jpg
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still) Medium sized, half fake, artillery piece project. (The 1/4 Pounder) 
|
|
|
Threaded Mode