A plea for help: HUP dimensions needed!

[Jonathan Moore]

Of course Hanno you are right, i will be more specific in future. I've now got loads of information and thanks to the brilliant high definition pictures from Phil Waterman, Dimensions from Bruce and the sunny pictures and continuing information from Bob Morrison, I have more than enough to start constructing the rear body. Mean while ive been consentrating on the cab area, it seems to be slow going but iam getting there. The outer windscreen frame had to be re-made, as it had been constructed out of wood and odd bits of steel and consequently lacked all the fittings which i have had to make. I have cut and fitted all the cab floor struts that had been cut out and made some new floor plates. The engine cover required some repairs and I have had to make two new hold down clamps.

Now a question that i cant answer, which isnt suprising. On the front of my chassis there are two mountings, one on either side at the front of the engine, pictured below. They dont look like they have been added ans i assume that they are engine mountings, but if they are then for what engine?

Again thanks for all your help.

Regards,

Jonathan