Question - 19 set power supply.

[Bruce MacMillan]

ok, 24v is a whole different ball game (or hockey).

For a 2 wire 24v supply the negative goes to pin 1 and the positive goes to pin 4.

Set the switch inside the power supply to 24v.

You can only use the dynamotor position, the vibrator is disabled.

[peter simundson]

why the negative goes to pin
6 and the positive to pins 3 and 4?

Peter S

[Bruce MacMillan]

In a 2 wire 12v power cable the negative goes to pins 1 & 6. Positive goes to pins 3 & 4.

Because there are 3 ways to attach batteries there are 3 different power cables. They are not interchangable.

1) 12v 2 wire: +12 to pins 3 & 4, -12v to pins 1 & 6

2) 24v 3 wire: +24v to pin 4, 12v tap to pins 3 & 6, -24 to pin 1

3) 24v 2 wire: +24v to pin 4, -24v to pin 1

The 3 wire is used where you have 2 12v batteries in series. tapping at 12v allows you to use the vibrator supply.

Remember that the dynamotor sucks current big time on spin up. It can often trip power supplies that can't provide the juice.

[peter simundson]

You are across the pond. What I have is a ZB 10247, Supply Unit

Rectifier No 1, S1. Need to replace the 110 cord (no ground) and am doing

the Rectifier to 19 set Power cord. It has the cutest little red and black

plugs where the cord goes in the front. Any hints.

Peter S