|
|
#22
29-04-12, 11:24
|
||||
|
||||
Good weather starts work again!
Pedal plate primed.jpg
With the sun out again, pedal plate got welded & primed. Engine hatch 2..jpg As did engine cover. Engine hatch 3.jpg Engine hatch 4.jpg In fact, I also painted the inside edges, after two good coats of primer. I wouldn't normally paint edges alone, but the rest will not be seen once I layer the inside with heat & acoustic insulation. engine insulation.jpg Spent an hour cutting templates for the insides of cover, then cut the pieces of insulation. I had bought a metre (~3ft ish) which looked big in the shop but not so big when the templates were laid over it. More to come
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still) Medium sized, half fake, artillery piece project. (The 1/4 Pounder) 
|
|
|
Threaded Mode