Carrier Stainless Exhaust downpipes

[Jordan Baker]

Ok thanks for the suggestions. I wasn't able to really loosen off the elbow bolts due to lack of room from the engine. However I was able to get a pry bar in there and put a lot of force on them untill the manifold bolts grabbed. I then kept prying and turning the bolts in a little at a time. Eventually they did pull in and everything lined up.

So for the next person that goes to install them. Make sure the elbow bolts are new and loose. Im sure its a case of having 2 (engine,elbows) of the 3 parts firmly fastend down. Whereas if I had all 3 parts loose it should go in no problem.

Thanks for checking it today with you other carrier. I am very happy to have them and not have had to go with the flex pipe and clamps. Thanks for taking the time to make them.