2011 at the Hammond Barn

[RHClarke]

The weather this morning was more seasonal than the last few mornings, so with nothing better to do, I spent the morning at the Hammond Barn. The tasks this morning included finish cleaning up my rusty tools, and to install the rear fender to running board connector plates (that's what I call them anyway). The plates attach to the end rail of the running board and to the fender itself. A quick check of the Prototype HUP surprised me - both the front and rear fenders attach directly to the running boards. The 45 HUP only has the rear fenders attached to the running boards. I guess this gives the 45 a little more flexibility going cross country.

Back to the job - the fenders were not too cooperative. Not surprising as they were bent, twisted and torn up when I got the HUP. They now look good, but there was some twisting when they got repaired that made the installation of the plates more of a challenge.

The trick to installing the plates was to use force. The fenders were unbolted from the frame to allow for some movement. The plates were attached to the running board by four bolts and nuts. The running board was raised by using a jack and this generally lined up the screw holes in the top of the plate and on the fender. Four large slotted round headed machine screws were attached through the fender and then through the plate by four nuts. This made the plate draw the fender to it and the fender actually looks properly lined up.

Once the jack was removed, the fender bolts were retightened, and the job was complete.

Photos:
1- The plate
2- The fender layout
3- Front view
4- Back view
5- New artwork at the Barn (part of the Hammond Art Appreciation Program)