|
|
#1
20-05-11, 07:37
|
|||
|
|||
Cutting Armour plate
Hi All,
Has anyone got any suggestions or hints on the best way of cutting armour plate? I will probably use an Oxy torch rather than a 9" angle grinder due to access to power. What gas settings etc would be good and tip size. The hull I am attacking is well past restoration but still has a few useful panels and other fittings needed for another carrier owner who is about to embark on the long road to restored condition. Rob
__________________
"Preserving our Military History" Done! LP2A Carrier 25 Pounder 18 Pounder Limber 2 Pounder 105 Pack Howitzer Waiting!!! No. 27 Limber Ford Lend Lease Truck C60L C15 F60 (Monkey Face) with 2Pdr Portee 
|
|
|
Threaded Mode