|
|
|
|
#2
08-01-11, 23:41
|
||||
|
||||
who ever bought Martyns Mk1 will need a full set, but i dont know who got that carrier.
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). 
|
|
#3
10-01-11, 04:15
|
|||
|
|||
|
... and in the complete spirit of recycling, who has Berdan primed cartridge cases to donate to the cause? I sold a big pail to the metal dealer for a surprising amount of money many years ago.
__________________
Terry Warner - 74-????? M151A2 - 70-08876 M38A1 - 53-71233 M100CDN trailer Beware! The Green Disease walks among us!
|
|
#4
10-01-11, 08:46
|
||||
|
||||
|
Count me in thanks
I definately need two and possibly a third (will have to confirm) I have been chasing these items for about three years now with little hope over here.
Cheers Phill
__________________
Ford GPW Jeep USMC Ambulance Willys MB Jeep Daimler Ferret Mk 1 Daimler Ferret Mk 2 Land Rover S2A Field Workshop Land Rover S3 FItted For Radio x2 Land Rover Perentie GS (SASR) International No 1 Mk 3 2.5 Ton 4x4 International No 1 Mk 4 2.5 Ton 4x4
|
|
#5
10-01-11, 10:22
|
||||
|
||||
|
i have a fek load of victorian brass stair rods if you need brass to melt down (if you are making them from brass that is.
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#6
10-01-11, 13:56
|
||||
|
||||
|
How many sets are you going to need to bring the pattern costs down to an acceptable level? Or are they attempting to mould from an original?
__________________
Alastair Lincoln, UK. Under Restoration: 1944 No2 MK2 Loyd Carrier - Tracked Towing 1944 Ford WOT6 Lorry The Loyd on Facebook
|
|
#7
10-01-11, 14:14
|
|||
|
|||
|
Pretty good interest so far.... more would be nice.
I'm not moulding from an original directly as this will makes the finished part too small due to shrinkage. a new tool allowing for shrinkage is made (3d scanned so it's correct) then the casts are from that. part of the cost is in the set up which is the same regardless. Not sure if supplying our own brass will help but i can ask. Cheers Ben
|
 |
|
|
Hybrid Mode
