![]() |
|
#1
|
||||
|
||||
![]()
very good mate....i made a trolley to sit my tub on and took all the wheels etc off the hull.
just looking at your center bulkhead, are you going to leave it all one peice ie the square bits on the top corners are usually made from 8mm steel and the main bit is 5mm steel. the two squares are usually rivetted onto the plate ?
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). |
#2
|
|||
|
|||
![]()
Richard,
Yes I was going to leave them attached and then fake it by putting on the straps. I am very, VERY far from knowing all the ins and outs of these things but I couldn’t figure out the purpose of making them in separate pcs. Can you tell me why? Stephen |
#3
|
||||
|
||||
![]()
Those smaller seperate pieces are made from armoured plate. The rest is mild steel plate.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
![]() |
|
|