T16 restoration starts in earnest

[RichardT10829]

Andrew its a rolled edge and is very hard to fabricate, the metal is 16swg these were made in a press and without it, its very hard to get the metal to form correctly without it deforming. the ones i did i bent over sectional then brazed in the slits so it looks like it has been pressed. my other thoughts were to use steel brake pipe slit it then weld it onto the sheet however when i compared it to an original item the diameter of the pipe was slightly too small..... mind unless you had one held up against an original you would not know.

it will cost you in the region of $400 US to get a pair from John, then shipping and customs charges on top.

perhaps David (Horsa) could knock you up some paper patterns of his then you could make some yourself and save some cash. thinking on also i think the T16 sand guards have like a right angle flat bar welded onto the outside to carry a tool or something.....you will see on Davids thread.

Rich