Advice on first carrier

[Ben]

Thank you all

I'm not 100% sure what sort of project i'm after but access to manufacturing and restoration equipment isn't a problem if i did decide to go that route. I think an easier restoration first time out makes sense.

My biggest issue is what to look out for when buying one, what parts can be replaced/remade and what parts are the hens teeth?

I have read that buying one from Canada etc can be a better bet even with the shipping costs.

Do drawings exist to remake parts or do bits have to be made from original patterns?

I know I have loads of questions, but i'm keen to get the low down.

Thanks again

Ben