thank for the flower's!!
actually i used the mig welder at a high voltage and slower wire speed to make sure i had good penetration, also since those frame are high in carbon i preheated to a cherry red before welding and kept it hot for a while before leting it cool down on its own slowly to prevent any stress in the steel, it is important not to over heat it as it can become brittle because of the carbon , the mig welder combined with the mix gold gas and some nozzle dip make for very clean welds, i also used the plasma quite a bit to remove some material to cut down on grinding time.
as for progress pics , the more nice wheater the more progress , i do need to build a garage..lol
|
09-04-10, 01:59
Threaded Mode