2008 at the Hammond Barn

[sth65pac]

Originally Posted by Phil Waterman

See http://www.canadianmilitarypattern.c...MetalWork.html about half way down the page. I even cut 10 inch section out of the drop side body that I fitted to my Pattern 12. In the pictures below you can see a bit of that process. You'll note in some of the pictures that there is a added fan and even a cover over the Plasma unit to extend its duty cycle by adding more cooling.

Phil,
You're welcome to drop your plasma cutter at my place (just the little prob of weight & distance...)

I can make....late model lifting rings, hatch catch profiles, toolbox brackets, pioneer tool holders ... now back to the anvil, fire and hammers...

And the 'greening' has begun... Unlike you poor blokes.. Summer is here & painting is a breeze. I did my St*FF SH*T handle about 12 weeks ago.. I will get to enjoy the 'joys' of engine rebuilding shortly..

[Bob Carriere]

...... we discovered that if you blow across the water jacket opening while adjusting the valves ..... you can hear the air whistling out of the sparkplug holes..... the whistling stops your valve are adjusted dead on......

Grant and I intend to write a book on this latest technique!!!!


....and Phil...... how did you bend that pushrod......?

Boob

[RHClarke]

Guy, I found your "cadeau" about 5 minutes ago. It looks great! So far I am the only one at the barn, but progress is being realized...