Hi Tony, this might sound a bit difficult. You could try chaining a minimum 12tonne hyd jack to the underside of the pin. Wrap the chain around numerous times for safety. Once you put pressure on the jack you are then using the chassis for back pressure rather than having the jack on the ground and only using the weight of the gun for pressure. Once you have got a substantial amount of pressure on the jack, just leave it and let the pressure do the work. It would act like a hyd bearing puller. If you have got a 32 tonne jack an a big chain, all the better.
Good luck
Colin.
|
07-09-08, 06:21
Threaded Mode