|
|
#23
13-06-15, 03:34
|
|||
|
|||
Mike,
I must admit you have a knack for sourcing stuff. Looking at the insulator, it may not give you what you want. Perhaps what you may need is one of those gaskets with the four notches. The four notches are there so as you can put the gasket on any which way and one of them will give connection from the vacuum passage to the manifold interior. Depends on the carburettor I guess. Dave
__________________
Hell no! I'm not that old! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: Morris Commercial Piston Liners | Andrew Rowe | For Sale Or Wanted | 0 | 24-09-14 09:23 |
| For Sale: piston-ring-pin: Chevrolet Canada/US | Dirk Leegwater (RIP) | For Sale Or Wanted | 0 | 29-08-12 16:48 |
| Make your own piston rings | Mike K | The Restoration Forum | 0 | 11-08-11 14:45 |
| Wanted: Piston for Chev Engine | Willanthry | For Sale Or Wanted | 21 | 15-07-09 14:40 |
| Piston Rings | ron | The Restoration Forum | 8 | 25-01-09 11:45 |
Threaded Mode