|
|
#1
14-12-13, 15:08
|
|||
|
|||
Otter Bracket/mount ID Required!
On the new Otter there is a bracket/mount on both front wings, pictured below. It is about 12 inches high and appears to have a type of connector in the middle for electrical cable, there is also a hole in the wing below to take a cable. There are no holes in the top plate, so it doesn't look like anything was mounted on it.
Has anyone out there any good ideas ???? 
__________________
C15 TA 1944 Ford Lynx 1945 C8A HUP 1943 Willys MB Jeep 1942 New Zealand pattern wheeled carrier 1943 (project1) New Zealand pattern wheeled carrier 1943 (project2) 
|
|
#2
21-12-13, 17:33
|
||||
|
||||
|
James, the only thing I could think of could be semaphores, or side lights.
__________________
39 Austin 8 Tourer 42 Humber Heavy Utility 42 C15A Wireless Truck 43 Humber AC MK IV F133744 "Vandal" tri-owner 43 A27L Centaur MK III T185481
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drawing required for bren mount for carrier | darron swift | The Carrier Forum | 26 | 02-10-13 19:27 |
| Vickers toolkit bracket dimensions required--LP2 | Darrin Wright | The Carrier Forum | 3 | 05-08-12 14:55 |
| Bracket ID Required | B. Harris | The Carrier Forum | 1 | 06-08-11 10:10 |
| WTB M38A1 Antenna Mount Bracket | oldlithgow | For Sale Or Wanted | 9 | 13-07-11 18:56 |
| Mount Bracket | super dave | Post-war Military Vehicles | 4 | 23-12-10 07:20 |
Linear Mode
