|
|
#7
10-03-08, 12:23
|
|||
|
|||
Brad
Barry is onto it.
It is part of the drain mechanism. It mounts to the floor beside the diff extention housing. The spindle is a couple of feet long and goes up top. it has another support at the rear plate inside the engine covers. The bit of the spindle you have is the bit at the bottom that connects to a round plate, that seals the hole through the floor. I only know because this is the set up in my OP no1 Mk3w. Lynn.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
|
Threaded Mode