Axles/brakes CGT
This CGT had no brakes when I got it, no surprise, but once I sandblasted the shoes they came out just like new as they were not being used. No reason to replace shoes as they are the old asbestos type which work better and can take more heat with out damage not like the modern carbon fiber type. Changed all 4 brake slave cylinders with new 1 1/2" brand name jobbers still commercially available.Both differentials were inspected, but I re-torqued all bolts; but great condition otherwise. The only issues were sourcing seals which I usually substituted for modern neoprene seals. These vehicles don't get a lot of usage tend to sit for months and will dry out leather type leaving you with little reminders every where you park. I used a vernier to measure old seals ID and OD measurements and bring the old seals and bearings to the bearing and seal suppliers for match up. The only bearings that I changed were all 4 wheel bearings as they showed signs of water damage and brinelling from sitting in one spot parked for a long time I guess? Kept a list of all jobber part numbers for seals and bearings for the future. This is a 6" front axle set up. I used a heavy coating of Lubriplate brand grease as it has good properties like rust prevention and won't absorb water as much.The rear drums were turned and I had to replace both fronts with NOS ones which I found locally as they were egg shaped.
Gaskets were usually eliminated with a top quality silicon based gasket eliminator at the hub mating flanges, differential covers.I found this prevents most leaks.
|
01-03-08, 18:13
Threaded Mode