#1
|
|||
|
|||
WS 19 MkII jeep install questions
All,
I’m installing one of my MkII 19 sets in my jeep. I’ve not seen any install instructions for a Jeep, so I’m just interpolating from some of the install instructions I’ve seen. For the power cable, am I correct in thinking that I need either the Connector, Twin, No. 88, or the Connector, Twin, No. 194? I’m also going to need an Aerial Feeder Assembly, but which one? Lastly, this set has been inactive for years, but I’ve opened it up and it looks good on the inside. From what I’ve read, I need to apply low voltage, approx 3 volts for about four hours. If nothing grenades, then I need to gradually increase the power until I get to full power, that being 12 volts. Just how am I supposed to accomplish this? V/R James D Teel II Edmond, Oklahoma MVPA 30889
__________________
V/R James D. Teel II Edmond, Oklahoma Retired Police Sergeant/Bomb Tech 1943 Willys MB/ITM jeep 1942 SS Cars No1Mk1 LtWt trailer |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1944-45 Jeep Questions | Johan WILLAERT | The Softskin Forum | 46 | 24-10-18 18:30 |
Wanted: Control Unit No.1A for jeep install | Johnny Canuck | For Sale Or Wanted | 0 | 28-03-16 17:25 |
Mk.19 Radio install photos? | Alan Wise | The Carrier Forum | 1 | 13-08-11 23:41 |
M Series/VRC 12 Cabling and Install Questions | Scott Bentley | Post-war Military Vehicles | 3 | 23-03-11 17:59 |
Jeep engine overhaul questions | Phill | The Softskin Forum | 3 | 01-08-09 17:01 |