|
|
#11
01-03-19, 22:13
|
||||
|
||||
Grant, I did think about the work hardening but they were fine.
Today I greased up the new front out wheel bearings. I ordered a pair of Timken 399a’s. They pressed in just fine. I also installed new hub seals. Lastly I removed the front left steering knuckle for rebuilding. I’ll need to work out the inner axle seal and the felt for the seal. One question on the rebuild of the knuckle. I’m planning on sandblasting the outer part but what should I do about the polished surface where there is some rust? I don’t feel that sandblasting is the best
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode