|
|
#32
09-09-17, 00:59
|
||||
|
||||
Out
Well now it was out, a small task of removing broken bolts.
Yep, tried the weld a nut on method. Failed. Tried the drill small and managed to snap a 1/4" drill in the middle of one bolt then two either side of the two big holes.  Drilled around the edges on one broken drill and then with a diamond point chisel chipped away for just on 6 hours. I managed to get all of the old metal out and no damage to the threads in either hole. After getting out the dirt and crap I ran a half cut bolt and cleaned up the threads. Now on to clean the case all up and put in new seals. Cheers, Ian
__________________
Ian Williams F15A, 2x Army Land Rover 88' sIIA's GPW Other stuff 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| starting handle cover | Maurice Donckers | The Carrier Forum | 30 | 23-08-14 03:40 |
| Crank Starting | Harry Moon | The Softskin Forum | 6 | 23-07-13 23:16 |
| Starting 1942 mb jeep | Little Jo | The Softskin Forum | 6 | 16-06-11 03:10 |
| Hot engine starting | Barry Read | The Carrier Forum | 17 | 13-05-06 19:25 |
| Jeep Starting Point | Campbell Finlay | The Softskin Forum | 5 | 04-01-05 08:47 |
Threaded Mode