Starter switch

[Malcolm Towrie]

I'm sure this must have come up on here before but I can't find anything by searching

I need a new mechanical starter switch for a Mk II Canadian Carrier. The switch is shown in the first pic below. Anyone have a part number?

Does a new switch come with the insulating plate and copper contact bar that are bolted to the casing, as shown in the second pic?

Also, has anyone wired from the small lug shown in the second pic to the coil negative terminal to bypass the ballast resistor while cranking?

Malcolm

20160602_191417.jpg

20160602_192400x.jpg

[rob love]

Isn't it the same switch as a 1940s chevrolet? http://www.ebay.com/itm/Ignition-Sta...dVn-0V&vxp=mtr

Alternate/OEM Part Number(s): 1858200, 277628, 820052, DR464 , 1S5216

As for the bypass, I think you would need to put a diode in the bypass wire so the starter motor doesn't try to draw current from the distributor.

[Malcolm Towrie]

Similar but not exactly the same. The sheet metal cover on the Carrier switch has a kick-out at the push-button end that looks like it is needed to cover the nut and stud on the casing shown above.

DSC02810x.jpg

Thanks for the reminder about the diode. I had forgotten about that.

Malcolm

[rob love]

Ah, I see that now. Perhaps you could gut the chevy switch (or any of the many similar switches used on tractors) and move new contacts into the original switch.

Doesn't have to be a diode for the wire of course. You could go old school and use a relay. But there are diodes small enough that you can almost hide them within the sheathing for the wire.

Personally, I use a 12 volt battery on my starter, and the 6 system merely runs the distributor, a solenoid, gauges and lights. Incredible starting without the load of the starter on the system.

[Lynn Eades]

Malcolm, these were common back in the day. What about cleaning yours up?
Don't sand it, file it. I'd guess the other contacts are not badly burned. You could judiciously re shape the one we've seen if there is not enough travel?
If you check out the part number you will then know if they are special to the MkII* or if they are common to commercial stuff. I assume it is an Autolite starter? when you have a part number, try mr google. Good luck!

[Malcolm Towrie]

Originally Posted by Lynn Eades

If you check out the part number you will then know if they are special to the MkII* or if they are common to commercial stuff. I assume it is an Autolite starter? when you have a part number, try mr google. Good luck!

Lynn, which part number do you mean? There is no number on the switch and I don't have a parts list for this Carrier (at least I can't find one in our "library").

Malcolm.

[Malcolm Towrie]

Originally Posted by rob love

Ah, I see that now. Perhaps you could gut the chevy switch (or any of the many similar switches used on tractors) and move new contacts into the original switch.

Rob,
It's not the contacts that are the problem, they're in reasonable shape, it's the insulating sheet and washers that are falling apart.

I'll get one of those Chevy switches and see if I can use the parts as you suggest.

Malcolm