looking for part numbers again.

jason meade · #1 23-01-12, 20:52

Hey, I am looking for more local part numbers again.
This is for a 44 chev c15a.
Tie rod,
Brake shoes,
and brake flex lines
Or a modern replacement part...Any ideas?
Jason

Bob Carriere · #2 25-01-12, 00:51

Hi Jason

On the tie rods...... I have been watching EBay for years and never seen anything that is even similar and found no other dealer source..... maybe Dirk might have some.... the only sav ing grace is that they can be taken apart and you can salvage parts to make a good one...

On the brake shoes...... remember they are Ford.... I found it cheaper to have the shoes relined locally...full set about $100 and you may want the drum turned lightly just to clean them up....

ON the flex hose.... if you have a old ones some of the better (older) local parts men can look them up .... I foudn mine at Car Quest...picture attached.

On the radiator spout for the cab 11/12 the my only one spare is on a radiator that is too good to be taken apart..... I would not trust the existing core in the one I have but the top and bottom tank with drain plug and snout are worth too much just to pull off parts from it.

The instrument panel glass and the vinyl decals are best availalbe from Chev of the Forties.....

Gord Yeo redid his cluster with their parts and it looks very good.

Last good used cluster on EBay went fo $113 USA $$$

Bob

Hanno Spoelstra · #3 25-01-12, 20:14

Hi Jason,

Did you look here? Modern part numbers for CMPs

HTH,
Hanno

jason meade · #4 25-01-12, 23:26

Hanno, Its a broken link.

Hanno Spoelstra · #5 25-01-12, 23:28

Quote:

Originally Posted by jason meade

Hanno, Its a broken link.

Jason, sorry, link now fixed.

H.

jason meade · #6 26-01-12, 01:23

Thanks Hanno, Ya i searched that one but nothing there that fits the bill.

Phil Waterman · #7 29-01-12, 16:19

Hi Jason

One of your parts number/source question concerned brake lines. Well it took me awhile to find my notes.

Well if the lines you are looking for are K,G, and O in the picture above or the rear hose. They are standard Weatherhead/Eaton hoses the part number is WH 81430?? with the ?? marks being the length in inches. For the HUP I used WH 8143017.

Now here are some other useful online resources:

Weatherhead/Eaton Master Brass Fitting Catalog http://hydraulics.eaton.com/products...I-MC001-E3.pdf

Weatherhead/Eaton Master Hose Catalog http://hydraulics.eaton.com/products..._Section_A.pdf this one is more technical and not as useful as I'd like but did figure out what I needed for the big flex oil lines.

Cheers Phil