![]() |
|
#1
|
|||
|
|||
![]()
Been doing a little bit of work on a 6 pounder, cheers to Rob for the tips!
Got a broken trail to repair and a stuck breech to free up. So far Iv'e been dousing the breech with peneterating oil for close to 2 weeks, made a press and gave it 12 ton from an old jack, no sign of movement. Will try again tomorrow using hardwood blocks as the pine just crumpled. |
#2
|
|||
|
|||
![]()
More photos
|
#3
|
|||
|
|||
![]()
And another one
|
#4
|
|||
|
|||
![]()
Last photo tonight, will try the breech again tomorrow. I posted a vid of me towing the gun down my drive on utube, called it "carrier and 6 pounder park up in the shed" also thought I should say its not my gun, just doing a little bit of work on it. Cheers
|
#5
|
|||
|
|||
![]()
Hi Lew, have done this job with a few 25pdr before.
Dumb question, no offence... you are pressing the breech block down not up? I own a ruined breech and block that someone took a sledge hammer to. ![]() |
#6
|
|||
|
|||
![]()
Lew,
Hardwood blocks or I use a selection of steel blocks for direct pressure, I doubt penetrating fluid will do anything on a block inside the ring from my experience's but you may need some heat and a bigger hydraulic jack. Just double check for any spot welds ! you may need to shock it when its under pressure so buy a nice big copper lump hammer as this absorbs impact and does not bruise the steel component's. Rob....................rnixartillery. Last edited by rnixartillery; 27-07-19 at 20:58. |
#7
|
|||
|
|||
![]()
Yep, going down with the breech. I think the pine was just soaking up the pressure, will block it up with metal blocks as I must have burnt my old hardwood blocks last winter (just checked the shed). Did you give the top of the press a knock with a hammer with pressure applied to shock it out Rob? Or on the breech block
Will go in search of an enerpac tomorrow. Last edited by Lew Skelton; 08-06-15 at 11:24. Reason: Added a sentance |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
My Day at Work | rob love | The Sergeants' Mess | 9 | 21-10-14 04:01 |
Too hot to work here! | Keith Webb | The Sergeants' Mess | 40 | 22-01-13 11:10 |
Work on My F8, No. 11 | Jim Price | The Softskin Forum | 163 | 24-08-09 19:54 |
Need to know how these work, please | BIG MIKE | The Carrier Forum | 16 | 11-10-05 07:06 |
C8 at work ? | Mike K | The Softskin Forum | 9 | 03-08-04 15:19 |