F60L spare wheel holder

[Ivo Rmoutil]

Hi
Does anyone have a drawing of a spare wheel holder on the right side?
Thanks

[Ivo Rmoutil]

The holder is made according to the photo.

[rob love]

Thanks for posting this. My 3 ton is missing that side bracket.

[Jacques Reed]

Hi Ivo,

Great job done there!

Slightly different design to my Australian F-15A wheel holder bracket. Then again, the wheel holder is also different to Canadian ones.

Mine is actually made from two pieces of 1/8" steel plate spot welded together. The spots are visible in the photo. I am hoping mine is original and not a later fabrication. If it is, at least it was well done and looks like another one I have seen.

Even rivetted to the chassis as per original- nice. Mine should be too but obviously the brackets were donors from another vehicle hence bolted on.

Cheers,

[Ivo Rmoutil]

Hi. These are not rivets but tear-off nuts, then ground into a cone.

Originally Posted by Jacques Reed

Hi Ivo,

Great job done there!

Slightly different design to my Australian F-15A wheel holder bracket. Then again, the wheel holder is also different to Canadian ones.

Mine is actually made from two pieces of 1/8" steel plate spot welded together. The spots are visible in the photo. I am hoping mine is original and not a later fabrication. If it is, at least it was well done and looks like another one I have seen.

Even rivetted to the chassis as per original- nice. Mine should be too but obviously the brackets were donors from another vehicle hence bolted on.

Cheers,

[Jacques Reed]

Hi Ivo,

Very effective! Could have never guessed they were not rivets.

Cheers,