[Darrin Wright]

Busy weekend and start to the week.
Managed to use the front left of the hull as a tool/mounting point to fit up a couple of front stub axle mounting plates to remove front wheels and salvage the bearings and spacer plates.
When finished I mounted the repaired and painted LHF stub axle mounting plate to the hull.

Installed the fan shroud and fitted the generator to check the fit. Looks good so far, unfortunately I had to remove the LH upper coolant pipe. Luckily I have not got around to filling with coolant as I am still researching and debating using waterless coolant or a rust inhibitor/coolant with distilled water.

Continued the assembly of the drivers floor plate, cleaned threaded sections, installed anti-seize, fit clevis yokes correctly, installed a new bearing onto the steering column, individually measured, cut & drilled new clevis pins for the yokes. Still missing some items like the left & right threaded turnbuckles, so will get them made in the next couple of weeks.

After the weekend, flew to Adelaide for work and to catch up with Colin Jones over coffee. Checked out his Acco 6x6 project, progressing well. He has set himself a busy schedule for March 2015. Then back to Melb Tuesday.