right. here are some pics from the underside hope they are ok
the countersink cutter i used was a Maykestag cobalt cutter 16.5 x 90 i use a slow speed drill and drill into the plate to create an OD of 15 - 16mm then with my setting snap i know i need an 11mm tail on the rivet (after its come through the armour that is)
http://www.ebay.co.uk/itm/16-5mm-Cob...ht_1797wt_1270
hope this helps matey
Richie
__________________
is mos redintegro
__5th Div___46th Div__
1942 Ford Universal Carrier No.3 MkI*
Lower Hull No. 10131
War Department CT54508 (SOLD)
1944 Ford Universal Carrier MkII* (under restoration).
1944 Morris C8 radio body (under restoration).
|