|
|
#1
24-01-16, 20:47
|
||||
|
||||
Bogie Pivot pin breather.
Having cleaned up the ones that I have I can get the ball to move against the spring but it doesn't seem to seat properly at all as you can blow and suck from the threaded end. I would presume that it should only let air pass out or at least have some sort of bias or it might as well just be an orafice! As I cant believe that it gets too hot I am inclined to just fit two grease nipples. What is peoples experience?
__________________
Alastair Lincoln, UK. Under Restoration: 1944 No2 MK2 Loyd Carrier - Tracked Towing 1944 Ford WOT6 Lorry The Loyd on Facebook 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bogie rear fork pivot seal | ajmac | The Carrier Forum | 3 | 27-01-14 18:13 |
| For Sale: Front Axle Pivot Bearings Blitz 4x4 | jim sewell | For Sale Or Wanted | 1 | 04-11-12 05:32 |
| For Sale: Armor pivot bolt | JBizal | For Sale Or Wanted | 4 | 10-08-12 06:22 |
| Front axle pivot bearings | jim sewell | For Sale Or Wanted | 0 | 17-09-09 12:19 |
| Chrysler air breather.... | Bob Carriere | For Sale Or Wanted | 12 | 15-03-07 14:55 |
Threaded Mode