|
|
#1
01-12-23, 03:45
|
||||
|
||||
Hello All,
Here is a question to the engineers amongst the forum. What do you think this brass block was made for? I visited one of the local scrap metal merchants to buy some brass. I found a 50 mm square solid brass block with the following inscribed 1.438 DIA. INV#10495 It seems like a precision made engineering gauge for measuring such things as rubber 'O' rings or seals to check to see if they are made within a specific tolerance. Well, that is my guess. How close to the mark am I? Kind regards Lionel Brass Gauge Block 1.jpg Brass Gauge Block 3.jpg Brass Gauge Block 4.jpg
__________________
1940 Chevrolet MCP with Holden Built Cab (30 CWT). 1935 REO Speed Wagon. 1963 Series 2A Army Ambulance ARN 112-211 Series III ex-Military Land Rovers x 2 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: 25 pdr Brass plates | rnixartillery | For Sale Or Wanted | 0 | 27-12-20 18:23 |
| where does the brass plate for the WS/19 go? | Jim Burrill | The Carrier Forum | 2 | 13-03-14 23:58 |
| Wanted: 105mm brass shells, 20mm brass shells, .50cal brass shells | Hans Mulder | For Sale Or Wanted | 4 | 30-10-13 00:44 |
| What are these brass plates | Little Jo | The Softskin Forum | 13 | 30-04-12 03:30 |
| Brass brake block | rusty linc | For Sale Or Wanted | 3 | 29-06-11 16:30 |
Threaded Mode