#1
|
||||
|
||||
MLVW info sought
Looking for references, actual documents (i.e., MOST reports, etc..) and hi-resolution photos for the MLVW family of vehicles.
Clive
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#2
|
||||
|
||||
Maybe a new book in the series???
__________________
Dano McLaren "VVV" M-152 55-45810 M-37 52-30890 M-220 CDN 53- Iltis 85-87789 LSVW Trailer 2910-1210 M-100 CDN M-101 CDN2 Chev 5/4 76- OMVA MVPA AVMQ CAFA CAFL |
#3
|
||||
|
||||
Absolutely! The Weapons of War series is up to 39 titles in print and more in the pipeline.
Clive
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#4
|
|||
|
|||
manual
Hello Clive
I have a manual you can borrow. Not sure how much info is in it though. I have some photos as well. Eric
__________________
Collecting data on the WW2 Canadian jeep and trailer. Serial, WD Numbers etc. |
#5
|
||||
|
||||
Thanks Eric. These will be helpful.
C
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#6
|
|||
|
|||
manual
Hello Clive
I will put them aside for you. I remember we had a conversion course for those of us already trained on the 2.5 tons. we all dreaded having to change a tire. Eric
__________________
Collecting data on the WW2 Canadian jeep and trailer. Serial, WD Numbers etc. |
#7
|
|||
|
|||
I think I have (or had) some of that course training package downstairs. I instructed on the conversion courses back around 83. Actually, you did not instruct, you merely assisted, since it was a self taught course for the most part.
I know what you meant about the spare tire removal. I watched as a Brute of a PPCLI tried to remove the tire from the holder....he was literally shaking the whole truck. Yet I, as a 160 pound craftsmen, could remove and replace the spare on the holder without issue. It was a brains over brawn thing. I picked up an MLVW a few weeks ago, and have been working on it since. It had been in a rollover accident and then cannibalized, so the fun has been trying to find all those little bits and pieces, and get them to fit where they belong. It is slowly progressing. |
#8
|
||||
|
||||
Roll Over
Rob and Clive,
I was in a MLVW roll over in 1985 while doing my TQ3 Infantry with the Militia in Petawawa while I was with the 2 IR RC. 18 troops in the back and 3 in the front. 2 bows kept the whole thing from laying flat on its roof. Luckily someone decided to leave the FNC1's at the bivowac as we were going to the rocket range. I wish I had a photo to show how the roof folded like a beer can. I do have a few pictures from my TQ3 Crewman that might show some CFR's Dave
__________________
Dave 302 Trooper M38 CDN 52-31093 M38A1 CDN 53-32350 M38A1 CDN-2 67-08251 2MP PL M38A1 CDN-3 70-08650 Windsor Regt M38A1 CDN 3 71-09013- Project M-100 Trailer 52-70078 M-100 Trailer 53-70177 LOSV Alpine 83-49816- Project LOSV Alpine 85-76533 TA-43 x2 |
#9
|
||||
|
||||
The info I am seeking is generic; date of intro, date of taken out of service, different SEVs/Qties, etc...
Photo needs are also generic as these are for an upcoming Weapons of War title. If I get enough info I will add to RamTank.ca with CFrs and photos. Cheers, C
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#10
|
|||
|
|||
Clive
I have had no luck finding the MOST pubs which are somewhere in the basement. To date I have only found one issue, along with one portion of the training package. The MLVW will still be in service in the regular force for another 3-5 years according to the guys who work on them. This is evidenced by the tender requests for parts....the quantities of stock they are looking to buy, considering they are only dealing with about half the old fleet, are considerable. As well, the trucks which were scheduled for destruction, in this area at least, are now being held for cannibalization to keep the remaining fleet operational. |
#11
|
||||
|
||||
I may be able to help.
I'm the token RegF guy working RSS at a Militia Unit here in the NCR. I think we may even have an MLVW or two, if not, I'm certain one of the other three Units in the Armoury has one. Books shouldn't be a problem. Anything specific you're after? PM me. Scotty
__________________
Gone but never forgotten: Sgt Shane Stachnik, Killed in Action on 3 Sept 2006, Panjwaii Afghanistan |
#12
|
|||
|
|||
Quote:
__________________
Terry Warner - 74-????? M151A2 - 70-08876 M38A1 - 53-71233 M100CDN trailer Beware! The Green Disease walks among us! |
#13
|
||||
|
||||
One of my challenges is identifying the many SEVs and their relevant ECCs.
C
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#14
|
|||
|
|||
I have a large poster downstairs of a MLVW, however I believe it is the prototype/trials truck. The CFR is out of whack for a MLVW, and there are a few anomalies on it.
Note that the mirrors are attached above the doors, the hood is held down with metal catches, there is no heater inlet (heater not installed?), the headlights have no brush guards, and the instruction plates on the side gates are not the long Cdn bilingual type. Also, it does not have a Jerry can holder on the step. Lastly, it is not camouflaged, which a truck from the 80s should have been. There is something odd on the hood over the hood safety latch....no idea what is going on there. |
#15
|
||||
|
||||
Quote:
Could it be a US truck acquired for trial by the MOST office? C
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#16
|
|||
|
|||
Most likely. It does exhibit some of the MLVW traits already, so it's hard to say if this is a US truck with modifications, or a truck built up here. It has the Cdn exhaust, which may indicate it has the 8.2 detroit and the Allison transmission.
If someone were to run the CFR 37735 shown in the photo on the EDR viewer it should give the model and serial number. The CFRs around it could also be checked to see how many were procured. |
#17
|
|||
|
|||
Us m35
CFR 37735 was a 1978 US M35. It was one of two, the other was a 1979.
|
#18
|
||||
|
||||
Rob,
In light of Ed's post on the CFR, can I get a scan of your poster, or a photo without any glare? Clive
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#19
|
|||
|
|||
Clive
Certainly, I'll give it a whirl. |
#20
|
|||
|
|||
Further to the search for MLVW PMO pubs, I had a look downstairs tonight and managed to find one more, so I now have issues no 3 and 4 available for you Clive. But somwhere I know I have the whole works of them in a binder, where they move on to the Iltis and even touch on the HLVW.
While looking I also stumbled onto the 1-1/4 ton truck bulletins for the 1976 gas 5/4 tons. I have issues no 3, 4, 5 and 6 if you ever decide to write about these un-interesting trucks. |
#21
|
||||
|
||||
Rob,
That's great news. I am really looking for issue #5 (on the Iltis) but ultimately am trying to get copies (or scans) of every edition. Stuff can be sent to; PO Box 33071, Ottawa, ON K2C 3Y9 C
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#22
|
|||
|
|||
Clive
I will mail you what I have and you can scan, copy, or trace whatever you like and send them back to me when youre done. Do you want the 5/4 ton stuff as well? |
#23
|
||||
|
||||
Sure. I never know what I will need down the road. Thanks for your support.
Clive
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#24
|
||||
|
||||
Gentle prod.
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#25
|
|||
|
|||
Ack!
I'll get it into an envelope now. Edited to ad:Now in an addressed envelope and should be in the postal system tomorrow. Last edited by rob love; 24-09-13 at 05:23. |
#26
|
||||
|
||||
Thnx.
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#27
|
|||
|
|||
Quote:
The article talks about 5 pre-production prototypes. I wonder if these prototypes are the modified US trucks. As well I have attached a shot of my MLVW as it sits now, although there is that white stuff all over it again, as happens every year around this time. Last edited by rob love; 06-12-13 at 05:31. |
#28
|
|||
|
|||
Clive
Another MLVW MOST bulletin fell out of my bookcase today. This one covers modifications for the MLVW, introduces the ILTIS, and touches on the start of the 5 ton replacement project. It is bulletin no5: did you need this one? I also have the EME journal from sometime around 1980 which covers the MLVW project. I can loan you that as well if you want. |
#29
|
||||
|
||||
Quote:
Absolutely!! MOST #5 was an issue that I have been looking for. A future project is the MLVW so all info is welcome. Cheers, C
__________________
Those who live by the sword will be shot by those of us who have progressed. - M38A1, 67-07800, ex LETE |
#30
|
|||
|
|||
I'll get them into an envelope now.
|
|
|