#1
|
|||
|
|||
CMP front hub
Just a quick question to the CMP readership out there..
My 15cwt front hubs have 3 holes drilled and tapped around the shaft.They have set screws in them. Are these intended to be used to remove the wheel bearing inside the hub? If so has anybody tried it, can it be done without applying heat? Your assistance greatly appreciated. B.P. Hub.jpg |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Front Axles for 10 bolt Front Hubs-1.5 ton Australian Chevrolet Trucks 1940-1945 | Philippe Jeanneau | The Softskin Forum | 30 | 28-01-22 10:19 |
Wanted: M72 front cap | Dave Jackson | For Sale Or Wanted | 0 | 15-08-19 00:37 |
Front Brake Drums-10 bolt Front Hubs for 1.5 ton Australian Chevrolet Trucks, 40-45 | Philippe Jeanneau | The Softskin Forum | 1 | 10-04-19 20:51 |
M4 front end | Perry Kitson | The Armour Forum | 3 | 10-06-17 15:22 |
Bedford military-front and civvy-front types | David_Hayward (RIP) | The Softskin Forum | 67 | 07-01-09 17:20 |