#1
|
||||
|
||||
Hi gUYS
I was worried when I found water in my oil and also in the oil filter. So the first thing I did was drain the water out of the radiator and to my surprise it was clean and had no rust or oil in it. Then I drained the oil out of the sump and that was all milky so I knew it was contaminated with water. Well I took the plunge and removed the head today and found the following: 1. The gasket seemed OK but when you pressed it water came from it. 2. Number 3 and 4 pistons had about 2 mm water on top of them 3. The thermostat looks like it will have to be replaced as the thermostat housing just disintegrated when I removed it. I have attached some photos after I removed the head and before cleaning out the water on top of the pistons. Now do I just replace the head gasket and pray all is well or is there something else I should be looking at as well while it is at this stage. Cheers Tony
__________________
Anthony (Tony) VAN RHODA. Strathalbyn. South Australia |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
water bag holder | oztankboy | The Softskin Forum | 25 | 21-02-19 02:52 |
Bedford MWC water | austin tilly | The Softskin Forum | 34 | 15-05-11 15:59 |
Water Trailer | acmva | For Sale Or Wanted | 0 | 14-07-10 18:07 |
FS: M1917 Water Cooled MG M1 Water Can | Steve Greenberg | For Sale Or Wanted | 0 | 17-11-09 17:34 |
Water | Rookie | The Sergeants' Mess | 9 | 30-03-08 01:02 |