#1
|
|||
|
|||
Lp2a
Hello!
I am going to start building the engine covers for my carrier and I need the dimension of the three pieces that form the sides and the top pieces including the vent. The only LP2 that I know of in the states also has fabricated engine covers. Any help would be greatly appreciated. Thanks, Carl |
#2
|
||||
|
||||
Engine Covers
Carl
There are a few more than three pieces to the complete engine cover for Aussie Carriers. What bits do you require?? All photos I have seen of your carrier ( or at least what I think is your carrier ) - have had the engine area covered with a green poly-tarp. Perhaps if you posted some pics of your carrier with the tarp off we could advise you which pieces you will need, or will need to make. Pedr |
#3
|
|||
|
|||
Hello Pedr
Thanks for the reply. I was thinking of something else when I typed in three pieces, I need all the major panels that are in the photo you posted. The vent would be like the one in the middle of the photo, not like the one on the right. If any one has the latch assemblies to hold the engine access panels on I would buy those. I still am unable to post photos yet but as soon as I can I will. My carrier is missing the entire engine doghouse so any help would be appreciated. Thanks, Carl |
|
|