#1
|
||||
|
||||
MkII Carrier Tail/Rear Light Pictures
Does anyone out there have some pictures of a MkII rear tail light? I can't seem to find anything in the reference books. I see it in the wiring diagrams in our manual but nothing that is illustrated or shows what it looks like.
Thanks,
__________________
Richard Hatkoski 1940 CMP C11 C-8 (Restoring) 1940 CMP C11 F-15A (Parts) 1941 CMP C12 C-15A (Parts) 1942 CMP C13 F-60S Dumper (Restoring) 2 x 1941 CMP C12 F-GT (Storage) 194? CMP C13 C-60X (For Sale) |
#2
|
|||
|
|||
Unless I forget..
it's a normal CMP tail light with a red plastic lens. I think the original had a woven wire cover outside the wiring.
Peter S |
#3
|
||||
|
||||
MkII tail light position
Peter, thank you for the response. I happen to have a red CMP rear light. Where do you think it was mounted on the rear of a MkII? Again, I haven't seen a picture of a tail light on a MkII so any information you have would be helpful.
__________________
Richard Hatkoski 1940 CMP C11 C-8 (Restoring) 1940 CMP C11 F-15A (Parts) 1941 CMP C12 C-15A (Parts) 1942 CMP C13 F-60S Dumper (Restoring) 2 x 1941 CMP C12 F-GT (Storage) 194? CMP C13 C-60X (For Sale) |
#4
|
|||
|
|||
Richcam
Here is a rear end of a MkII, and it shows you were it isnt. So it has to be at the top of the tool board somewhere, buried by the folding down of that lid. have a look at the back of this Mortar carrier. I think it is mounted at one of the two bolt holes that are enpty, at the top of the tool board.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 30-10-10 at 20:32. |
#5
|
||||
|
||||
Tail Light Positioning
Lynn,
Thanks for the pictures. I now have a good idea of where I'm going to put it. We hope to have our Legion MkII carrier operational for the Huntsville Rembrance Day parade on Nov. 11th.
__________________
Richard Hatkoski 1940 CMP C11 C-8 (Restoring) 1940 CMP C11 F-15A (Parts) 1941 CMP C12 C-15A (Parts) 1942 CMP C13 F-60S Dumper (Restoring) 2 x 1941 CMP C12 F-GT (Storage) 194? CMP C13 C-60X (For Sale) |
#6
|
|||
|
|||
Attached are four photos of the tail light on the rear of a MkII carrier with towing attchment. At the side of the hood there is a hole for a toggle switch(which is not fitted) for remotely turning the light off.
Perry |
#7
|
||||
|
||||
Tail Light on my UC No2MkII*
Hi Chaps,
Take a look, this is the correct location and the correct light. It indeed has a woven cover on the wire. Perry's light is actually a front light, hence the white lens. Cheers, Marc |
#8
|
||||
|
||||
Proper Tail light position
Perry & Marc,
Thank you for the clarification and the pictures.
__________________
Richard Hatkoski 1940 CMP C11 C-8 (Restoring) 1940 CMP C11 F-15A (Parts) 1941 CMP C12 C-15A (Parts) 1942 CMP C13 F-60S Dumper (Restoring) 2 x 1941 CMP C12 F-GT (Storage) 194? CMP C13 C-60X (For Sale) |
#9
|
|||
|
|||
After 14 or so years of saying I should change the lens in the tail light, I have finally been shamed into doing it. Note also the difference between the towing attachments. There may have been changes during production, or perhaps between different manufacturers.
Perry Last edited by Perry Kitson; 02-11-10 at 16:55. |
#10
|
|||
|
|||
Here is a tip on the lenses for the CMP lights: They do tend to shrink and disintegrate over time. What I used to do was save the different color lenses in the broken army flashlights (they come with a variety of spare lenses held in the tailcap, blue, red white) and using a gasket punch would cut out the appropriate size lens for the cmp taillight from them.
|
#11
|
|||
|
|||
On my canadian Mk11* I have a light both on the back of the carrier which is wired in, and one on the towing hook as shown in the other postings which is not.
Presumably my carrier either started off life without a hook or the light on the hook is a later mod on early Mk11's? |
#12
|
||||
|
||||
Quote:
Dirk |
#13
|
||||
|
||||
Dirk,
Then I need a Canadian light! Do you have one in stock? With red lens of course.
Cheers, Marc |
#14
|
|||
|
|||
Marc
I know you will want to change it, but the military would have fitted what was available.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
#15
|
||||
|
||||
Wrong or right?
Quote:
You're right. They did. That's also what happened during the restauration I think I will try to get a Canadian light and store that for future use if anything happens to my British light. Cheers, Marc |
#16
|
|||
|
|||
I would be tempted to change it for a Canadian light as the one you have fited is not even the standard British pattern used on Carriers.
|
#17
|
|||
|
|||
Niel
Can you put up a picture of the right one. Thanks.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
#18
|
||||
|
||||
Here is the correct WW2 British army tail light. Ron
|
#19
|
|||
|
|||
Yes that the correct late war pattern from approx 43 onwards.
Prior to this the rubber pattern was used. I believe Dirk still has the canadian version of these for sale. Other types were used on different truck contracts but these are the two principal patterns. |
#20
|
||||
|
||||
Quote:
Keep watching our website. Dirk Last edited by Dirk Leegwater (RIP); 14-11-10 at 17:36. |
|
|