|
|
#1
25-03-10, 06:46
|
|||
|
|||
C15A radiator support brackets
Hi all , After many years I have finally got my truck ( C15A , cab 13 , c 1943 ) running but I cant put the front of the cab on till I make the radiator support brackets , If anyone could send or post some photos of the radiator support brackets , I would be very appreciative , regards Jim.
|
|
#2
25-03-10, 12:52
|
|||
|
|||
|
Jim
Can you clarify what brackets you are talking about? Are they the rods that run back from the "U" shaped radiator support to the uprights in the Cab 13 structure beside the engine that run up from the floor frame to the windshield frame? I don't have a good photo or dimensions of the rods, but I'm sure someone else will.
|
|
#3
25-03-10, 15:20
|
|||
|
|||
|
Here are a couple of pictures
Hi Jim
I assume that you mean the U shaped bracket that Grant is speaking of here are 2 pictures of it on my Pat 13 C60S if this the correct one I'll dig for more photos. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
|
#4
26-03-10, 03:55
|
|||
|
|||
|
Thanks Phil and Grant , I wasnt sure if they attached to the side rails or the cross bar underneath , the rods to the cab wont be a problem , I have the radiator mounted with about 20mm between it and the fan , not sure if there was a cowl around the fan , so I'll make some supports up soon . Here is a pic of how she looks now , Jim
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
