#1
|
||||
|
||||
What do we see here? 3-ton trucks with GS body moved forward
Please ID the trucks in this photo. (The one on the right is easy.)
Picture courtesy of Brendan O’Carroll
__________________
Regards, Hanno -------------------------- |
#2
|
|||
|
|||
Interesting, Hanno, that the CMP in the foreground is running sand tires while still retaining its factory original chevron tread spare.
David |
#3
|
||||
|
||||
I see 4 CMP F30s, with stripped down 11/12 Cabs for cooling.
I would say LRDG Patrol trucks, but I haven't seen the spare tyre mounted to the side like that before.
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! |
#4
|
||||
|
||||
F30s? Or are these are 158” w.b. 3-ton trucks with roofless Cab 13 and the GS body moved forward with the spare wheel fitted to the side of the body?
__________________
Regards, Hanno -------------------------- |
#5
|
|||
|
|||
I would say LWB F60L's, but I am with Tony that I are most likely cab 12's...but I am not putting any money on it, as there is something strange about the trucks.
Cab 13's have the front part of the fenders fitted to the front clip....so, if the clips are removed, than you can't fit the front part of the fender. But the picture does show full fenders. Or do the trucks in the picture retain the cab13 front clips, and were the sides cut out of them??? What about the GS bodies? Is that a drop shadow under the top edge of the body......or did someone cut holes in the sides? I think Hanno's is right that the bodies have been move forward, but I understand the design of the long wheelwells allowed the bodies to either be fitted with, or without, the spare wheel carrier. It's certainly a fascinating picture, Hanno!
__________________
Chevrolet C8 cab 11 FFW BSA Folding Bicycle |
#6
|
||||
|
||||
I don't like having to refer to scale models to depict a vehicle, but they do show the vehicle well: F30. Note that the model has 2 toolboxes under the front of the tray, the photo trucks only have 1 toolbox and a POL rack, making the rear wheel arch appear longer.
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! Last edited by Tony Smith; 22-06-21 at 23:42. |
#7
|
||||
|
||||
The clue to being a 30cwt is the rear tailshaft visible on the vehicle on the far right; 134wb has a gentle slope from the rear diff to the transfer case, the 158wb has a steep angle to a bearing block in between.
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! |
#8
|
||||
|
||||
I think I see the side of the 3-ton GS body with the four sections and the wheel well cover covering the third and part of the fourth section. Compare with these pics:
__________________
Regards, Hanno -------------------------- |
#9
|
||||
|
||||
Quote:
And when are you going to tell us the source of the photo?
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! |
#10
|
||||
|
||||
A sand channel can be fitted, yes. Don’t you see the four side sections? I will view it again on a large screen. There’s definitely something modified.
Pic comes from Brendan O’Carroll, have asked him if he has a better scan.
__________________
Regards, Hanno -------------------------- |
#11
|
|||
|
|||
Quote:
__________________
Chevrolet C8 cab 11 FFW BSA Folding Bicycle |
#12
|
|||
|
|||
I played with the contrast and color a bit and agree they are 20" wheels. The dish of the wheels are the giveaway. As well, if you look at the diameter of the spare compared to the 3 ton cargo box, the tires are much higher than a 16" tire would be.
Hard to understand why they would go to all the trouble to remove the spare tire carrier and move the box forward. The weight saving is negligible. |
#13
|
|||
|
|||
Remember not all CMPs had spares
Hi Rob
I understand it that not all CMPs were equipped with spares if they had RUN FLAT tires, I have some 10:50x20 and 10:50x16 with dates from 1941 and 1942 marked RF4 which are extremely heavy and have thick side walls. I remember reading that trucks with the Run Flats only every 3rd or 4th truck would originally carry be equipped with spare. Now I'll have to go back through the handbooks and Bill Greggs books for the source of the information. Now back to these trucks equipped sand tires which were by nature much softer and subject to puncture, carrying a spare or two would be logical. As to removing the hood and side panels to help cool the engines. While it might help with engine cooling it sure does not help with cooling the driver or co-driver. I've driven my Pattern 12 in 90F+ air temperatures with out the side hood panels and it was miserable. Same temps with panels and hood on doors open on the hooks and the windscreen open halfway was semi tolerable. No doubt in my mine Patter 13 is much better. But even the Pattern 13 in 80-90F temperature the air in the drivers footwell can hit 124F+. I now have a thermometer under the dash to remind me when it is getting to hot. The truck is fine I'm the one passing out from the heat. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#14
|
|||
|
|||
Quote:
Agreed about 20" wheels, obvious on the 13 cab in the foreground and a bit less so on the 11/12 cab in the background. I think the background trucks are most likely 11/12 cab based on the positioning if the post at the front of the door and general proportions of the truck nose but am not good enough to tell if Ford or Chev on any of the trucks. Last edited by Grant Bowker; 23-06-21 at 21:36. |
#15
|
|||
|
|||
From my time working in Kandahar, I doubt it would make a whole lot of difference wrt the heat from the engine being blown towards the driver. During the summer there, any breeze or wind felt like standing in front of a Herman Nelson heater. At least it helped evaporate some of the sweat. 90° would be a very cool day there in the summer time.
|
#16
|
||||
|
||||
Righto
Four 11/12 Cabs.
Wheelbase 134 inch either 30cwt or 60S? (I think they made 12's in S configuration... happy to be corrected). Definitely 20 inch rims. My line of logic for the 60L body would be for more cargo area. When youre out in the desert... I would think any extra room for water/ammunition in a forward area would be invaluable. Place a spare around the side and youre good to go.
__________________
Pax Vobiscum.......may you eat three meals a day & have regular bowel movements. |
#17
|
||||
|
||||
Quote:
It offers a good view of what the 3-ton GS body looks like sitting more forward after the spare wheel holder behind the cab was removed. I am now convinced these are 158” w.b. 3-ton trucks with roofless Cab 11 or 12 and the GS body moved forward with the spare wheel fitted to the side of the body.
__________________
Regards, Hanno -------------------------- |
#18
|
||||
|
||||
"We've got him!"
Quote:
__________________
Regards, Hanno -------------------------- |
#19
|
||||
|
||||
“Somewhere in the desert between Egypt and Libya”
Two photos of a Cab 13 3-tonner with its GS body moved forward.
Notice the spare wheel holder dangling from the left hand side of the GS body. Source:
__________________
Regards, Hanno -------------------------- |
#20
|
||||
|
||||
Quote:
Quote:
Alan Hall, 2010: Toby Savage, April 2012:
__________________
Regards, Hanno -------------------------- |
#21
|
|||
|
|||
Dear all,
Interesting enough one can find pictures of LRDG Ford F30 (I think also here on MLU), where the body has been moved BACK (for better weight distribution over the rear wheels?) allowing for a spare wheel behind he cab. Cheers, Martin |
#22
|
||||
|
||||
Quote:
Indeed, the LRDG modified (some of) their F30s. The body was moved back to improve the weight distribution for driving in the desert. Re. these 3-ton trucks, I am pretty sure the LRDG Heavy Section did not alter the body, but that these trucks were delivered as such.
__________________
Regards, Hanno -------------------------- |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LSVW near Ottawa - moved | maple_leaf_eh | Auction and Classified Ad Site Heads Up | 4 | 16-12-16 03:00 |
moved from Canadian Tulip Festival | Michael R. | The Sergeants' Mess | 1 | 19-04-15 19:45 |
britsh forward control 3 ton trucks | Les Freathy | The Softskin Forum | 60 | 09-04-11 05:41 |
My CMP finally got moved! | Pedro Bedard | The Softskin Forum | 4 | 25-10-10 05:35 |
125 ton pillbox moved to neighbours! | Hanno Spoelstra | WW2 Military History & Equipment | 3 | 23-09-07 08:16 |